Adjustments
Height of Cut Adjustment
The height of cut is adjustable from 1 to 5 inches in 1/2
inch increments. Positioning the castor wheel axles in
the top holes of the castor forks or pivots (see Chart
below) allows low range height of cut settings from 1 to
3-1/2 inches. Positioning the castor wheel axles in the
lower holes of the front castor forks or rear castor pivots
allows (see Chart below) high range height of cut set-
tings from 2-1/2 to 5 inches.
1. Start the engine and raise the cutting unit so height
of
cut can be changed. Stop engine after cutting unit is
in raised position.
2. Position all castor wheel axles in the same holes in
th
e castor forks or pivots.
Figure 4
Adjustments P
age 8 - 4 Groundsmaster
®
455-D
To Next Page
Loading...
