Installing the Engine
1. To install the engine, perform steps 2-14 of Removing
the Engine in reverse order.
2. After disassembling or overhauling the engine, install
a new oil filter. Replace this filter after the first 20 to 50
hours of operation.
3. Fill the engine with the correct oil. Fill the cooling
s
ystem with a 50/50 solution of ethylene glycol anti-
freeze, and clean, soft water. Check for oil and coolant
leaks and repair as necessary.
Peugeot recommended Coolant/Antifreeze is available in 1 U.S.
Gallon containers under Toro Part No. 93-7213.
IMPORTANT: The anti-freeze should contain no
Borate and have a Ph of 7 to 8.5.
4. Adjust the throttle linkage.
Engine Page 3 - 44
Rev
. B
Groundsmaster 455-D
To Next Page
Loading...
