PTO Clutch Adjustment
1. To adjust clutch, tighten or loosen locknuts on flange
studs.
2. Check adjustment by inserting feeler gauge through
slot
s next to flange studs.
3. The proper disengaged clearance between the clutch
plates is 0.011 - 0.021 inches. It will be necessary to
check this clearance at each of the three slots to ensure
the plates are parallel to each other.
1
2
Figure 3
1. PTO clutch
2. Flange studs
Adjustments Page 7 - 4 Groundsmaster
®
455-D
To Next Page
Loading...
