PTO Clutch Service
Figure 15
1. Retaining ring 5. Armature ass’y (Items 1, 2, 4, 5) 8. Field rotor ass’y (Items 6, 7, 8)
2. Bearing 6. Field coil assembly 9. Spring
3. Brake plate 7. Field bearing 10. Locknut
4. Bearing collar
NOTE: Individual parts (such as bearings) in the field 3. Separate the armature assembly (Item 5) from the
rotor assembly or armature assembly are not service- field rotor assembly (Item 8).
able and must be replaced as an assembly.
4. Reassemble the two clutch halves (armature assem-
1. Remove the clutch assembly (see Clutch Removal bly
and field rotor assembly).
and Installation in this section of the book).
5. Install the three (3) springs (Item 9) over the studs.
2. Remove the three (3) lock nuts (Fig. 15, Item 10). Install the brake plate (Item 3) and the three (3) locknuts
Remove the brake plate (Item 3) and three (3) springs (Item 10).
(Item 9).
Repairs P
age 7 - 14 Groundsmaster
®
455-D
To Next Page
Loading...
