Blade Removal and Installation
The blade must be replaced if a solid object is hit, the
blade is out of balance or if the blade is bent. Always
use genuine TORO replacement blades to be sure of
safety and optimum performance. Never use replace-
ment blades made by other manufacturers because
they could be dangerous.
CAUTION
Do not try to straighten a blade that is bent,
and never weld a broken or cracked blade.
1
85 - 110 ft-lb
Always use a now blade to assure continued
safety certification of the product.
Figure 23
1. Raise cutting unit to highest position, shut the engine
1. Blade bolt
off and engage the parking brake. Engage locking
2. Flat washer (S/N below 30001)
latches to prevent cutting unit from falling accidentally.
3. Anti-scalp cup
2. Grasp end of blade using a rag or thickly padded
glove. Remove blade bolt, washer (if equipped) anti-
scalp cup and blade from spindle shaft.
NOTE: Units with S/N below 30001 will have a hex bolt
and fla
t washer securing the blade. Units with S/N
30001 & up will have a hex flange bolt securing
the blade.
3. Install blade sail facing toward cutting unit with anti-
s
calp cup, lockwasher and blade bolt. Tighten blade bolt
to 85 - 110 ft-lb.
Cutting Unit
Groundsmaster
®
455-D Page 8 - 15
Rev. A
Repairs
To Next Page
Loading...
