Figure 29
Properly orient the end cap (Item 14) and housing (Item Place gasket (Item 11) on housing (Item 9), then install
9). Refer to previously scribed lines for assembly guide. end cap and valve plate. Hold the valve plate so it does
not drop off during assembly.
Pr
ess the bearing (Item 11) into end cap (Item 14)
leaving 3/32 to 1/8 inch of bearing protruding beyond Install four (Item 4) screws (Item 16) and tighten alter-
face. The valve plate (Item 1) pilots on this bearing. nately until the end cap and housing are pulled com-
pletely together. Torque to 27-37 ft. lbs. Check for proper
I
nsert locating pin (Item 13) into end cap. Lubricate the internal assembly by slowly rotating motors shaft while
slotted side of the motor valve plate (Item 1) and slip it tightening these screws.
over the locating pin and protruding bearing.
Hydraulic System
Groundsmaster
®
455-D Page 4 - 45 Repairs
To Next Page
Loading...
