Toro Outcross 9060 Series - Changing the Hydraulic Fluid and Filters

uidappearsabovetheuppermarkonthe
dipstick.
g246148
Figure115
8.Insertthedipstickandplugintothehydraulic
tank
9.Checkallhydraulichosesandttingsforleaks.
ChangingtheHydraulic
FluidandFilters
ServiceInterval:Aftertherst1000hours
Every1,500hours
Ifthehydraulicuidbecomescontaminated,contact
yourauthorizedT orodistributor;thesystemmustbe
ushed.Contaminateduidlooksmilkyorblackwhen
comparedtocleanuid.
Important:UseTororeplacementlters;referto
themachinePartsCatalog.Usinganyotherlter
mayvoidthewarrantyonsomecomponents.
1.Parkthemachineonalevelsurface.
2.DisengagethePTO,movetheshiftleverto
theNEUTRALposition,lowerallattachments(if
equipped),engagetheparkingbrake,shutoff
theengine,andremovethekey.
3.Placealargedrainpanunderthehydraulic-uid
tank.
4.Removethehydraulic-tankcapanddipstick.
5.Removethedrainplugfromthebottomofthe
tankandletthehydraulicuidowintothepan
(Figure116).
g248961
Figure116
1.Hydrauliclters
2.Drainplug
6.Installthedrainplugwhenthehydraulicuid
stopsdraining.
7.Cleantheareaaroundthelter-mountingareas.
8.Placeadrainpanunderthelterandremove
thelter(Figure116).
9.Lubricatethenewltergasketandllthelter
withhydraulicuid.
10.Ensurethateachlter-mountingareaisclean
andscrewthelteronuntilthegasketcontacts
themountingplate;thentightenthelteran
additional1/2turn.
11.Fillthereservoirwithhydraulicuid;referto
CheckingtheHydraulic-FluidLevel(page77).
Important:Useonlythehydraulicuids
specied.Otheruidscouldcausesystem
damage.
12.Installthereservoirdipstickandcap.
13.Starttheengineanduseallofthehydraulic
controlstodistributehydraulicuidthroughout
thesystem.
Note:Also,checkforleaks,thenshutoffthe
engine.
14.Checktheuidlevelandaddenoughtoraise
theleveltotheFullmarkonthedipstick.
Note:Donotoverll.
78