Toro Outcross 9060 Series - Installing Spacers for Category 1 Attachments

g261477
Figure4
1.Hairpincotter
3.Swaylink
2.Clevispin
4.Installedclevispinand
hairpincotter
5.Useaclevispinandahairpincottertosecure
theswaylinktothedraftlink(Figure4).
6.Installaclevispinandhairpincottertothesway
link(Figure4).
Usethepinandcottertoadjusttheswayas
neededforyourattachment;refertoAdjusting
theSwayLinks(page27).
InstallingtheTopLink
1.Installtherodtothetoplink(Figure5).
g262057
Figure5
1.Rod2.Toplink
2.Installthetoplinktotheupper-linkbracketon
themachine;refertoInstallingorRemovingthe
TopLink(page26).
InstallingtheDrawbar
1.Use2screws(M18)and2washerstosecure
thehammerstraptothedrawbar(Figure6).
g261154
Figure6
1.Hammerstrap3.Washer
2.Drawbar
4.Screw(M18)
2.Torquethescrewsto338to393N∙m(250to
290ft-lb).
3.Installthedrawbartothedrawbarsupport;refer
toInstallingtheDrawbarHitch(page25).
5
InstallingSpacersfor
Category1Attachments
Partsneededforthisprocedure:
1Top-linkbushing
2
Lift-armbushing
Procedure
IfyouinstallaCategory1attachmenttothe3-point
hitch,installspacerstothetoplinkandtheliftarms;
refertoInstallingSpacersforCategory1Attachments
(page28).
14