Toro Outcross 9060 Series - Page 27

AdjustingtheLiftLinks
LevelingtheAttachmentSide-to-Side
Note:Adjustingtheliftlinksaffectstheparameter
settingsforallattachments.Maintaina1cm(3/8inch)
lengthofexposedthread.
1.Loosenthejamnutoneitherliftlink(Figure24).
2.Adjusttheliftlinkinoroutuntiltheattachmentis
level(Figure24).
g308989
Figure24
1.Jamnut
2.Liftlink
3.Tightenthejamnut(Figure24).
AdjustingtheSwayLinks
Note:ChecktheattachmentOperator’sManualfor
adjustingtheswayprocedure.Formostimplements,
asmallamountofsway(13to25mmor1/2to1inch)
isneeded.
Note:IfyouareattachingaCategory1attachmentto
themachine,usetheappropriatespacersandhubs.
1.Removethehairpinandcotterpinoneachsway
link(Figure25).
2.Adjusttheswaylinkinoroutuntiltheimplement
islevel(Figure25).
3.Afteradjusting,securetheswaylinkwiththe
cotterpinandhairpin(Figure25).
g308992
Figure25
1.Hairpin
3.Cotterpin
2.Swaylink
ConnectingtheRear
Power-Takeoff(PTO)
1.Parkthemachineonalevelsurface,movethe
shiftlevertotheNEUTRALposition,engagethe
parkingbrake,shutofftheengine,andremove
thekey.
2.Alignthequick-connectcouplingofthedriveshaft
withtheoutputshaftofthePTO(Figure26).
Note:YoucanrotatetherearPTOenoughto
aidinthesplinealignment.
g250417
Figure26
1.PTOoutputshaft
(machine)
2.Quick-connectcoupling
(driveshaft)
3.Pullbackthelockcollarofthedriveshaftyoke
(Figure27).
27