Toro Outcross 9060 Series - Page 26

g251287
Figure21
1.Drawbar—left-side-adjusted
position
4.Clevispin
2.Drawbar—centered
position
5.Hairpincotter
3.Drawbar—right-side-adjusted
position
2.Securethedrawbartothesupportbyinserting
theclevispinthroughtheoneofthethreemount
holelocationsinthedrawbarandattachingthe
hairpincottertothepin(Figure21).
Note:RefertoyourattachmentOperator’s
Manualforthecorrectdrawbarposition.
UsingthePintleHitch
Optional
ThePintleHitchKitisavailableforusewithyour
machine;seeyourauthorizedT orodistributor.
AdjustingtheTopLink
LevelinganAttachmentFront-to-Back
Note:IfyouareattachingaCategory1attachmentto
themachine,usetheappropriatespacersandhubs.
1.Loosenthejamnutonthetoplink(Figure22).
2.Rotatethecenterlinkuntiltheattachmentis
leveltotheground,fromfront-to-back.
g308984
Figure22
1.Toplink2.Jamnut
3.Tightenthejamnut(Figure22).
InstallingorRemovingtheTop
Link
Note:RefertoFigure23forthisprocedure.
Usethelynchpinandclevispintoinstallthetoplink
totheupper-linkbracket;removethepinstoremove
thetoplinkfromtheupper-linkbracket.
g308990
Figure23
1.Toplink3.Upper-linkbracket
2.Lynchpin
4.Clevispin
26