Toro Reelmaster 3555 - Page 63

g352088
Figure96
1.Reelspeedchartdecal
(platformcover)
2.Mowermanifold
4.Recordofthespeednumberatwhichthereel
speedcontrolknobisset.
g020248
Figure97
1.Backlaplever2.Reelspeedcontrolknob
5.Setthereelspeedcontrolknobtoposition1
(Figure97).
6.MovethebacklaplevertotheR(backlap)
position(Figure97).
Note:Themachineisinthebacklapmode
whenthemow/transportslidetotheright(MOW)
positionandthebacklapleverintheR(backlap)
position.
LappingtheReelsandBedknife
DANGER
Changingtheenginespeedwhilebacklapping
maycausethecuttingunitstostall.
•Neverchangetheenginespeedwhile
backlappingreelsandbedknives.
•Backlaponlyatidleenginespeed.
1.Starttheengineandallowittorunatlowidle
speed.
2.PressthecuttingunitdriveswitchtotheENGAGE
position.
g352634
Figure98
1.Lower
3.Cuttingunitdriveswitch
2.Engage
4.Lowermow/raisecontrol
3.Movethelowermow/raisecontrolleverforward
(Figure98).
Note:Thereelsofallcuttingunitsrotate
backward.
4.Applylappingcompoundtothereelwitha
long-handlebrush.
DANGER
Contactingthecuttingunitswhenthey
aremovingcouldcausepersonalinjury.
Toavoidpersonalinjury,becertainthat
youareclearofthecuttingunitsbefore
proceeding.
Important:Neveruseashort-handled
brush.
5.Ifthecuttingunitsstallorbecomeerraticwhile
backlapping,adjustthereelspeedcontrolknob
untilthereelspeedstabilizes,thenreturnthe
reelspeedtosetting1ortoyourdesiredspeed.
6.Ifyouneedtomakeanadjustmenttothecutting
unitswhilebacklapping,performthefollowing
steps:
63