Toro Reelmaster 3555 - Page 64

A.Movethelowermow/raisecontrollever
rearward.
Note:Thecuttingunitsshutoff,butdonot
raise.
B.Pressthecuttingunitdriveswitchtothe
DISENGAGEposition.
C.Shutofftheengineandremovethekey.
D.Adjusttothecuttingunits.
E.Repeatsteps1through5.
7.Repeatsteps4fortheothercuttingunitsthat
youwanttobacklap.
FinishingBacklapping
1.Pressthecuttingunitcontrolswitchtothe
DISENGAGEposition.
2.Shutofftheengine.
3.MovethebacklaplevertotheF(mow)position
(Figure99).
Important:Ifyoudonotchangebacklap
levertotheF(mow)positionafter
backlapping,thecuttingunitswillnotraise
orfunctionproperly.
g020248
Figure99
1.Backlaplever2.Reelspeedcontrolknob
4.Adjustthecuttingunitreelspeedcontrolto
settingthatyounotedinstep4ofPreparingthe
Machine(page62).
5.Closetheoorpanel.
6.Washalllappingcompoundofffromthecutting
units.
7.Forabettercuttingedge,runaleacrossthe
frontfaceofthebedknifeafterlapping.
Note:Thisremovesanyburrsorroughedges
thatmayhavebuiltuponthecuttingedge.
64