50
model 2000 DeviceNet Module Manual (DN611/DN611A)
Chapter 4 Operating Procedures for the DN611 (Software)
4
(2) Module Connection
Connect a DN611 into slot No. 6 of the main unit.
Double-click a blank slot in [Module Inner Connection Configuration] under [Main
Unit] to open the Module List menu.
Figure 4-3 Module Selection Menu
Select [DN611] on the module list menu so it appears in reversed color, and press the
[Connect] button.
Then, [DN611] is shown in slot No. 6 on the Hardwaree Configuration menu as
shown on the next page. [DN611] is shown in red, indicating that the registered data
has not yet been saved.
Choose "DN611"
Click "Connect(C)" button
To Next Page
Loading...
