ACE-tronics G9 ASD Installation and Operation Manual 97
Output Terminal 4 (OUT3) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT3 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT3 terminal to any
one of the user-selectable functions listed in Table 10 on pg. 242.
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for
additional information on the function of this terminal.
Direct Access Number — F133
Parameter Type — Se
lection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 5 (OUT4) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT4
di
sc
rete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT4 terminal to any
one of the user-selectable functions listed in Table 10 on pg. 242.
Note: The
Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for
additional information on the function of this terminal.
Direct Access Number — F134
Parameter Type — Se
lection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 6 (R1) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the R1 discrete output
terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable R1 terminal to any one of
the user-selectable functions listed in Table 10 on pg. 242.
Note: The
Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 Instruction Manual (P/N 58685) for
additional information on the function of this terminal.
Direct Access Number — F135
Parameter Type — Se
lection List
Factory Default — Always Off
Changeable During Run — No
F133 F135
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
