98 ACE-tronics G9 ASD Installation and Operation Manual
Output Terminal 7 (OUT5) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT5 discrete output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT5 terminal to any
one of the user-selectable functions listed in Table 10 on pg. 242.
Note: The Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for
additional information on the function of this terminal.
Direct Access Number — F136
Parameter Type — Se
lection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 8 (OUT6) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT6 di
sc
ret
e output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable OUT6 terminal to any
one of the user-selectable functions listed in Table 10 on pg. 242.
Note: The
Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for
additional information on the function of this terminal.
Direct Access Number — F137
Parameter Type — Se
lection List
Factory Default — Always Off
Changeable During Run — No
Output Terminal 9 (R2) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the R2 discrete output
terminal.
In addition, this output terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable R2 terminal to any one of
the user-selectable functions listed in Table 10 on pg. 242.
Note: The
Expansion IO Card Option 2 option board (P/N ETB004Z)
is required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for
additional information on the function of this terminal.
Direct Access Number — F138
Parameter Type — Se
lection List
Factory Default — Always Off
Changeable During Run — No
F136 F138
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
