44 ACE-tronics G9 ASD Installation and Operation Manual
Startup Wizard Introduction Screen
The introduction screen provides an opportunity to
exit the wizard before launching. Once started, the
wizard must be completed to exit the program.
Select Exit to terminate the wizard and configure
manually. Go to the Program screen and select the
parameters to be configured.
To continue with the wizard click Ne
xt.
Motor Capacity
This parameter is used to set the (Nameplate) rated
capacity of the motor being used.
Motor RPM
This parameter is used to set the (Nameplate) RPM
of the motor being used.
Motor Current
This parameter is used to set the (Nameplate) rated
current of the motor being used.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
