Toshiba ACE-tronics G9 ASD - Page 98

88 ACE-tronics G9 ASD Installation and Operation Manual
Preset Speed 3
Program  Frequency  Preset Speeds
This parameter assigns an output frequency to binary number 0011 and is
identified as Preset Speed 3. The binary number is applied to I1 – I4 of the
ACE G9-120V-PCB to output the Preset Speed (see F018 for additional
information on this parameter).
Direct Access Number — F020
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed 4
Program  Frequency  Preset Speeds
This parameter assigns an output frequency to binary number 0100 and is
identified as Preset Speed 4. The binary number is applied to I1 – I4 of the
ACE G9-120V-PCB to output the Preset Speed (see F018 for additional
information on this parameter).
Direct Access Number — F021
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed 5
Program  Frequency  Preset Speeds
This parameter assigns an output frequency to binary number 0101 and is
identified as Preset Speed 5. The binary number is applied to I1 – I4 of the
ACE G9-120V-PCB to output the Preset Speed (see F018 for additional
information on this parameter).
Direct Access Number — F022
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed 6
Program  Frequency  Preset Speeds
This parameter assigns an output frequency to binary number 0110 and is
identified as Preset Speed 6. The binary number is applied to I1 – I4 of the
ACE G9-120V-PCB to output the Preset Speed (see F018 for additional
information on this parameter).
Direct Access Number — F023
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed 7
Program  Frequency  Preset Speeds
This parameter assigns an output frequency to binary number 0111 and is
identified as Preset Speed 7. The binary number is applied to I1 – I4 of the
ACE G9-120V-PCB to output the Preset Speed (see F018 for additional
information on this parameter).
Direct Access Number — F024
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed 3
Preset Speed 4
F020 F024
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com