Toshiba B-EX4 SERIES - Ribbon Saving Module: B-Ex904-R-Qm-R

3. OPTIONAL KIT EO10-33024
3.3 RIBBON SAVING MODULE: B-EX904-R-QM-R
3-4
3.3 RIBBON SAVING MODULE: B-EX904-R-QM-R
By moving the print head up and down with a solenoid, the ribbon saving module saves loss of the
ribbon as far as possible. It is small enough to be put into the print block.
a) Non-stop ribbon save
(The function is selectable in the printer system mode.)
When a non-print area is detected while the printer is feeding or printing the media, this module raises
the print head to save the ribbon without stopping the media feed.
Note: Max. ribbon save amount is 50%.
b) Rotary cutter
When using the rotary cutter, the ribbon save function is required to be enabled.
Min. non-print area required to enable the ribbon save function
4", 203-dpi model
Print speed 3ips 6ips 10ips 12ips 14ips
Min. non-print
area 20mm 20mm 35mm TBD TBD
Reference (Components of the current
model)
1. Solenoid
2. Harness (Connected to the Main PC board)
3. Relay PC board (with harness)
4. Locking support
5. M4×8 Double sems screw
6. Cable clamp
7. Installation manual
8. Arm