Toshiba B-EX4 SERIES - RTC;USB Host INTERFACE BOARD: B-EX700-RTC-QM-R; Rfid Module: B-Ex700-Rfid-H1-Qm-R

3. OPTIONAL KIT EO10-33024
3.4 EXPANSION I/O CARD: B-EX700-IO-QM-R
3-6
3.4 EXPANSION I/O CARD: B-EX700-IO-QM-R
This interface board is used to connect the printer to external devices, such as a labeler. The
input/output signals from the connected external devices can control label feeding or printing and
indicate the print status.
3.5 RTC/USB host INTERFACE BOARD: B-EX700-RTC-QM-R
Installing this board enables a connection USB memory.
* Conforming to USB 1.1 USB HOST
* Supporting Full-speed (12M bps) transmission
3.6 RFID MODULE: B-EX700-RFID-H1-QM-R
Installing this module enables the printer to write data on an RFID tag as well as to print on the surface
of RFID supplies.
The three RFID module types are different from each other in frequency band and applicable countries.
HF RFID kit destined for Europe (RFID module and antenna are locally purchased.)
Although the specified frequency band can be used in the other countries than Europe, the destination
is limited to Europe because the certification is obtained only for Europe.
Antenna cover Nylon washer
Ribbon guide Spacer
RFID module plate
Installation
Manual
Antenna frame
Cord bush
Cable clamp
Harness
Screws
Specification
Item Description
Module TagSys MEDIO S002 (Locally purchased)
Frequency
13.56MHｚ
Output power 200mW
Environmental standard RoHS Directive
TagSys C210, C220, C240, I-Code, Tag-it,
Available RFID tags
ISO15693