Toshiba B-EX4 T1 Series - Page 30

2. SUPPLY SPECIFICATIONS SPTM-0152
2.2 RIBBON
2-14
2.2.5 NOTES
2.2.5.1 If printing is performed using only a narrow range of the ribbon as shown below, the
ribbon may wrinkle.
2.2.5.2 When a ribbon error occurs, the ribbon tension value for the ribbon feed motor should be
adjusted in the negative (−) direction. For details regarding the fine adjustment of the ribbon
motor drive voltage, refer to the Key Operation Specification (EAA-03184).
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
Feed direction
Feed direction
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF
ABCDEF