Toshiba B-EX4 T1 Series - EXPANSION I;O CARD: B-EX700-IO-QM-R; RTC;USB HOST INTERFACE BOARD: B-EX700-RTC-QM-R; RFID MODULE: B-EX700-RFID-H1-QM-R

3. OPTIONAL KIT SPTM-0152
3.3 EXPANSION I/O CARD: B-EX700-IO-QM-R
3-5
3.3 EXPANSION I/O CARD: B-EX700-IO-QM-R
This interface board is used to connect the printer to external devices, such as a labeler. The
input/output signals from the connected external devices can control label feeding or printing and
indicate the print status.
3.4 RTC/USB host INTERFACE BOARD: B-EX700-RTC-QM-R
Installing this board enables a connection USB memory.
* Conforming to USB 1.1 USB HOST
* Supporting Full-speed (12M bps) transmission
3.5 RFID MODULE: B-EX700-RFID-H1-QM-R
Installing this module enables the printer to write data on an RFID tag as well as to print on the surface
of RFID supplies.
The three RFID module types are different from each other in frequency band and applicable countries.
HF RFID kit destined for Europe (RFID module and antenna are locally purchased.)
Although the specified frequency band can be used in the other countries than Europe, the destination
is limited to Europe because the certification is obtained only for Europe.
Antenna cover Nylon washer
Ribbon guide Spacer
RFID module plate
Installation
Manual
Antenna frame
Cord bush
Cable clamp
Harness
Screws
Specification
Contents Specification
RFID Module TagSys MEDIO S002
(This module does not enclose to the kit)
Frequency 13.56MHz
Output 200mW
RFID Spec.
RFID Tag TagSys C210, C220, C240, I-Code, Tag-it,
ISO15693
Operation temperature 5~40 °C
Humidity 10 to 90% (Does not dew)
RFID module can write in using an evaluation tag sample,
About the write-in performance to a RFID tag, it is not a guarantee diplomatically in market.