Toshiba B-EX4 T1 Series - PEEL OFF MODULE: B-EX904-H-QM-R

3. OPTIONAL KIT SPTM-0152
3.2 PEEL OFF MODULE: B-EX904-H-QM-R
3-3
3.2 PEEL OFF MODULE: B-EX904-H-QM-R
This strip module consists of the take-up block and the strip block. Installing the strip module enables
the printer to not only remove labels from the backing paper, but wind the tag paper or label with
backing paper onto the take-up spool by using the rewinder guide plate. The rewind full sensor is
provided to detect the overflow if the wound tag paper or label exceeds the specified amount is
provided.
Specification:
Contents Specification
Peel-off method Rewind paper with DC motor.
Select SW Can selectable 2mode of rewind
function.
・ Standard Peel-off mode
・ Rewind mode
Note:Using this function should be
indication by print command.
Peel-off Sensor The sensor, which detects the Peel-off
label.
Function
Over flow Sensor The sensor, which detects the over
flow of rewind liner.
Operation temparature 5 to 40 °C
Humidity 10 to 90%（Does not dew）
EXPIO
Type1(STD)
3-10ips Print speed set to
10ips over,
operate 10ips
automatically
203dpi
EXPIO
Type2(In-line)
Selected print speed
Automatic pre-peel-off
mode for over 10ips.
Do not support
internal rewinder
EXPIO
Type1(STD)
3-8ips Print speed set to
8ips over,
operate 8ips
automatically
Print speed
300dpi
305dpi
EXPIO
Type2(In-line)
Selected print speed
Automatic pre-peel-off
mode for over 10ips.
Do not support
internal rewinder