Toshiba e-studio 202L - Display

5
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 CONTROL PANEL
5 - 3
5.2.1 Display
No. Message State of equipment Note
1 - Power is OFF (at Sleep Mode) Press [START] button or [FUNC-
TION] button to clear
2 Saving energy - press
START button
At Energy Saving Mode Press [START] button to clear
3 Wait Warming Up Scanner warming up
• Displayed until the equipment
becomes ready to start scanning
Auto Start can be set
4 Wait Warming Up
Auto Start
Scanner warming up
• Displayed when Auto Start is set
Press [STOP] button to clear the
Auto Start
5 WAIT Displayed when performing the con-
trolling function to keep the equip-
ment at the best condition
6 Wait adding toner Supplying toner
• Equipment becomes the toner
supply state
Recovers when the toner supply has
finished
7 Performing Auto Calibra-
tion
Displayed at image quality control Recovers when the image quality
control has finished
8 READY Ready for copying
• Waiting for the operation
9 READY
Press START button to
copy
Copying job interrupted Press [START] button to resume
copying or press [MEMORY CLEAR]
button to delete the job
10 READY
(WARMING UP)
Scanner warming up
11 READY
(PRINTING)
Printing out the data
• Scanning is enabled
12 READY
(ADDING TONER)
Supplying toner
• Scanning is enabled
13 READY
(INNER TRAY FULL)
Inner tray in the equipment is full
• Scanning is enabled
- When the bridge unit is installed
- Resumes printing by removing
papers from the tray
14 READY
(CHECK STAPLER)
No staples in finisher
• Scanning is enabled
Cleared by supplying the staples
15 READY
(CHECK STAPLER)
Stapling jam occurred in finisher
16 READY (ADD PAPER)
Press JOB STATUS button
No paper in drawer
• Scanning is enabled
Cleared by supplying papers
17 READY
(FINISHER FULL)
Finisher is full of paper
• Scanning is enabled
Resumes printing by removing paper
from the finisher
18 READY
(HOLE PUNCH DUST BIN
IS FULL)
Punching dust box is full
• Scanning is enabled
Resumes printing by removing
punching dust from the dust box
19 READY
(SADDLE STITCH TRAY
FULL)
Saddle stitcher tray is full of paper
• Scanning is enabled
20 READY
(CHANGE DRAWER TO
CORRECT PAPER SIZE)
Incorrect paper size setting
21 Ready for bypass feeding Paper is set on the bypass tray
22 COPYING At the copying state
23 Auto Start Auto Start is set during printing Cleared by pressing [RESET] button
or [STOP] button