e-STUDIO200L/202L/230/232/280/282 SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES June 2004 © TOSHIBA TEC
1 - 8
1.3.2 e-STUDIO202L/232/232S/282/282S
* 1) N: North America E: Europe F: France S: Sweden
Notes:
1. The bridge kit (KN-3520) is necessary for installation of the finisher (MJ-1022 or MJ-1025).
2. The saddle stitch finisher (MJ-1025) is necessary for installation of the hole punch unit
(MJ-6005N/E/F/S).
3. The PCI slot (GO-1060) is necessary for installation of the scrambler board (GP-1040).
4. The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1041) and
Bluetooth module (GN-2010).
5. When the wireless LAN module (GN-1041) and the Bluetooth module (GN-2010) are
installed, only 1 antenna (GN-3010) can be connected to each.
6. GM-1080U / GM-2080U / GM-4080U are exclusive to e-STUDIO202L. They do not operate
with e-STUDIO232/232S/282/282S.
Platen Cover KA-3511PC/-C
Reversing Automatic Document Feeder (RADF) MR-3020
Automatic Duplexing Unit (ADU) MD-0102
Drawer module MY-1021/-C
Slot cover KE-2330
Paper Feed Pedestal (PFP) KD-1011/-C
Large Capacity Feeder (LCF) KD-1012LT/A4/A4-C
Finisher (Hanging type) MJ-1022/-C
Finisher (Console saddle stitcher type) MJ-1025
Hole punch unit (for MJ-1025)
MJ-6005N/E/F/S
*1
Staple cartridge STAPLE-1600 (for MJ-1022)
STAPLE-2000 (for MJ-1025)
Bridge kit KN-3520/-C
Job separator MJ-5004/-C
Offset tray MJ-5005/-C
Work tray KK-3511/-C
Damp heater MF-3520U/E
Fax board GD-1150NA/EU/AU/AS/C/TW
2nd line for fax board GD-1160NA/EU-N/C/TW
Printer kit GM-1070/GM-1080U
Printer/Scanner kit GM-2070/GM-2080U
Scanner kit GM-4070/GM-4080U
Scrambler board GP-1040
Wireless LAN module GN-1041
Bluetooth module GN-2010
Antenna GN-3010
Data overwrite kit GP-1060
PCI slot GO-1060
Desk MH-1700
Harness kit for coin controller GQ-1020
05/11
To Next Page
Loading...
