9
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM
9 - 13
9.4 Disassembly and Replacement
[A] Bypass pickup roller
[B] Bypass feed unit
(1) Remove 1 clip.
(2) Pull out the shaft and take off the bypass
pickup roller.
Fig.9-9
(1) If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover (! P.2-38 "[P]
Right front hinge cover", ! P.2-39 "[Q] Right
rear hinge cover", ! P.2-39 "[R] Bypass
upper cover").
If the ADU is installed, take off the ADU (!
P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2) Remove 1 spring.
(3) Disconnect the connector of the bypass feed
clutch.
Fig.9-10
Clip
Shaft
Bypass pickup roller
Spring
Connector
04/09
To Next Page
Loading...
