16
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 POWER SUPPLY UNIT
16 - 5
16.4 Fuse
When the power supply secondary fuse is blown out, confirm that there is no abnormality with each part
using the following table.
Voltage Board/Unit Part Fuse type
+24VD1 LGC Main motor F4:8A (Semi time-lag)
Toner motor
Polygonal motor
Tray-up motor
Internal cooling fan 1
Internal cooling fan 2
Auto-toner sensor
Upper drawer feed clutch
Lower drawer feed clutch
Registration roller clutch
Upper transport clutch
Middle transport clutch
Lower transport clutch
Discharge LED
Main switch
PFP/LCF
+24VD2 LGC Exit motor F5:5A (Semi time-lag)
ADU motor
Exhaust fan
Bypass feed clutch
ADU clutch
Bypass pickup solenoid
High-voltage transformer
Key copy counter / Copy key card
Bridge unit / Job separator / Offset tray
+24VD3 RADF F6:4A (Semi time-lag)
+24VD4 SLG Scan motor F7:4A (Semi time-lag)
Exposure lamp (Inverter board)
+24VD5 Finisher F8:5A (Semi time-lag)
To Next Page
Loading...
