9
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM
9 - 5
9.2 Operation
9.2.1 Operation of bypass pickup roller
When the paper is set on the bypass tray, the bypass feed sensor detects the presence of the paper.
Then the bypass pickup solenoid is turned ON and the pickup arm falls by its own weight. At this time,
when the bypass feed clutch is turned ON, the drive from the main motor is transmitted to the pickup
roller through the gears and shaft. Then the paper is picked up.
The paper picked up is transported to the transport path in the equipment by the bypass feed roller.
When there is no paper remaining on the bypass tray, the bypass pickup solenoid is turned OFF and
the pickup roller returns by the spring force.
The separation roller works not to transport paper more than one sheet at a time.
Fig.9-3
Bypass feed clutch
Bypass Pickup roller
Bypass feed roller
Bypass separation roller
Spring
Pickup arm
Bypass Pickup solenoid
To Next Page
Loading...
