e-STUDIO200L/202L/230/232/280/282 DRUM RELATED SECTION June 2004 © TOSHIBA TEC
11 - 18
[P] 1st transport sensor
[Q] Exhaust fan
(1) Take off the transfer unit
(! P.11-17 "[O] Transfer unit").
(2) Extend the holder part to release the hook of
the protrusion.
(3) Rotate the guide and lift it up to take off.
Fig.11-32
(4) Disconnect 1 connector, release the latch,
and then take off the 1st transport sensor.
Fig.11-33
(1) Take off the ozone filter
(! P.11-15 "[L] Ozone filter").
(2) Take off the transfer/separation charger (!
P.11-15 "[M] Transfer/Separation charger").
(3) Take off the transfer unit
(! P.11-17 "[O] Transfer unit").
(4) Take off the guide
(! P.11-18 "[P] 1st transport sensor").
(5) Remove the plate spring.
Fig.11-34
Holder
Guide
1st transport sensor
Plate spring
05/07
To Next Page
Loading...
