e-STUDIO200L/202L/230/232/280/282 PAPER EXIT SECTION June 2004 © TOSHIBA TEC
14 - 6
[C] Paper exit drive unit
[D] Exit sensor
(1) Take off the paper exit unit
(! P.14-5 "[B] Paper exit unit").
(2) Release the harness from 2 harness clamps.
(3) Remove 3 screws and take off the paper exit
drive unit.
Fig.14-6
(4) Remove 3 gears and take off the timing belt.
And then slide the exit motor to the hole and
take it off.
Fig.14-7
(1) Take off the paper exit unit
(! P.14-5 "[B] Paper exit unit").
(2) Disconnect 1 connector and take off the exit
sensor.
Fig.14-8
Harness
clamp
Drive unit
Harness
clamp
Exit motor
Gear
Gear
Gear
Timing belt
Exit sensor
To Next Page
Loading...
