15
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 AUTOMATIC DUPLEXING UNIT (ADU) (OPTION: MD-0102)
15 - 13
[F] ADU clutch
[G] ADU motor / ADU drive unit
(1) Take off the ADU cover
(! P.15-12 "[E] ADU cover").
(2) Remove 1 E-ring and disconnect 1 connec-
tor. Then take off the ADU clutch.
Note:
When installing the E-ring, make sure that
the latches of both ends of E-ring are on the
flat part of the shaft.
Fig.15-18
(1) Take off the ADU clutch
(! P.15-13 "[F] ADU clutch").
(2) Remove the spring.
Fig.15-19
(3) Remove 1 screw and take off the ADU rear
latch.
Fig.15-20
ADU clutch
Shaft
E-ring
Spring
ADU rear latch
To Next Page
Loading...
