2
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 OUTLINE OF THE MACHINE
2 - 3
B14 2nd transport roller E8 Main charger
B15 Registration roller E9 Discharge LED
B16 Registration sensor E10 Doctor blade
B17 1st transport sensor E11 Drum thermistor
B18 2nd transport sensor E12 Developer sleeve (magnetic roller)
B19 Registration clutch E13 Auto-toner sensor
B20 Upper transport clutch E14 Toner recovery auger
B21 Middle transport clutch E15 Toner cartridge installation switch
B22 Lower transport clutch E16 Toner motor
B23 Side cover opening/closing switch E17 Main motor
C1 ADU upper transport roller E18 Drum damp heater thermostat
C2 ADU middle transport roller E19 Drum damp heater
C3 ADU lower transport roller F1 Laser unit
C4 ADU entrance sensor F2 Polygonal motor
C5 ADU exit sensor G1 Heat roller
C6 ADU motor G2 Pressure roller
C7 ADU clutch G3 Cleaning roller
C8 ADU opening/closing switch G4 Separation finger for heat roller
D1 Bypass pickup roller G5 Center/side/edge thermistor
D2 Bypass feed roller G6 Fuser center/front thermostat
D3 Bypass separation roller G7 Exit roller
D4 Bypass tray G8 Exit sensor
D5 Bypass paper sensor G9 Heater Lamp (center/side)
D6 Paper size detection sensor G10 Exit motor
D7 Bypass pickup solenoid H1 Temperature/humidity sensor
D8 Bypass feed clutch H2 Main switch
E1 Drum H3 Transfer cover opening/closing switch
E2 Separation finger H4 Front cover opening/closing switch
E3 Transfer charger H5 Cover opening/closing interlock switch
E4 Separation charger H6 Auger lock switch
E5 Developer unit H7 Internal cooling fan-1
E6 Cleaning blade H8 Internal cooling fan-2
E7 Recovery blade H9 Exhaust fan
To Next Page
Loading...
