2
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 OUTLINE OF THE MACHINE
2 - 39
[Q] Right rear hinge cover
[R] Bypass upper cover
Note:
e-STUDIO200L (NAD/ASD),
e-STUDIO230L (MJD),
e-STUDIO230/280 (ASD/ASU/SAD/TWD)
e-STUDIO202L (NAD/ARD),
e-STUDIO232 (ASD/ASU/SAD/CND/TWD/KRD/ARD),
e-STUDIO282 (ASD/ASU/SAD/CND/TWD/KRD/ARD)
(1) Remove 2 screws and take off the right rear
hinge cover.
Note:
When the ADU is installed, refer to chapter
15.5 (! P.15-10 "[A] Automatic Duplexing
Unit (ADU)")
Fig. 2-41
(1) Remove 1 screw, take off the harness cover.
(2) Take off the right front hinge cover.
(! P.2-38 "[P] Right front hinge cover")
(3) Take off the right rear hinge cover.
(! P.2-39 "[Q] Right rear hinge cover")
Fig. 2-42
Right rear hinge cover
Harness cover
05/11
To Next Page
Loading...
