2
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 OUTLINE OF THE MACHINE
2 - 47
[D-2] e-STUDIO202L/232/232S/282/282S
[E] Logic PC board (LGC board)
(1) Take off the SYS board cover (! P.2-41 "[A]
Hard disk (HDD)").
(2) Disconnect 4 connectors and release the
harness from 1 harness clamp.
Fig. 2-59
(3) Remove 5 screws and take off the SYS
board case.
Fig. 2-60
(1) Take off the rear cover
(! P.2-31 "[C] Rear cover").
(2) Loosen 4 screws and take off the bridge
bracket.
Note:
The LGC boards of e-STUDIO200L/230/
230L/280/280S and e-STUDIO202L/232/
232S/282/282S are different in appearance.
Fig. 2-61
SYS board case
Bridge bracket
05/11
To Next Page
Loading...
