7
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
IMAGE PROCESSING
7 - 5
(The following is the case that the low pass filtering is applied on the primary scanning pixel.)
Fig. 7-4
High-pass filter processing
Character outline blurs when the original, such as text, with big difference in density among the
pixels is optically scanned and output from the CCD. Characteristic of the lens and other factors
cause this phenomenon. In this equipment, processing such as edge enhancement is applied
between the targeted pixel and the neighboring pixels to eliminate this phenomenon and realize
high reproducibility of original.
Fig. 7-5
2) Image memory editing
This function performs editing such as enlargement/reduction, etc., by using a line memory. Pixel
data for one line in the primary scanning direction is stored in the line memory and the memory is
renewed at each line.
- Enlargement/Reduction
Enlargement/Reduction is accomplished by using the line memory control function in the process
of the image processing operation.
<Example> Enlargement
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9
Density
After low-pass filter
Primary scanning pixel positions
Density
Primary scanning pixel positions
Solid black area
Original
Image signal
To Next Page
Loading...
