12
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
DEVELOPMENT SYSTEM
12 - 11
12.6 Disassembly and Replacement
[A] Developer unit
Note:
Make sure to perform “05-280” and take off the process unit before the developer material is
replaced.
(1) Take off the Process unit.
" P.11-9 "[A] Process unit"
(2) Take off the drum cleaner unit from the pro-
cess unit so that only the developer unit will
be left.
" P.11-10 "[B] Drum cleaner unit"
Notes:
1. Be careful not to touch or scratch the
drum surface at this time.
2. Do not deform the Guide Mylar by touch-
ing this.
Fig. 12-6
Fig. 12-7
Developer unit
Drum cleaner unit
Guide mylar
To Next Page
Loading...
