e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
12 - 12
[B] Developer material
(1) Take out the developer unit
" P.12-11 "[A] Developer unit".
(2) Remove 2 screws and slide the developer
unit upper cover to the direction of the arrow
and take it off.
Fig. 12-8
Note:
When installing the developer unit upper
cover, make sure that the side seal comes
between the developer unit upper cover and
rubber seal on the cover.
Fig. 12-9
(3) Remove the developer material from rear
side.
Note:
When removing the developer material, be
careful not to drop the developer material on
the gears of the developer unit.
Fig. 12-10
Developer unit upper cover
Side seal
Rubber seal
Developer unit
upper cover
To Next Page
Loading...
