e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
CONTROL PANEL
5 - 2
5.2 Items Displayed on Control Panel
The following items are displayed in the 7-segment LED at the center of the control panel:
1) Copy quantity
The number of copies set (= copy quantities) is displayed in the normal state.
2) Reproduction ratio
The display switches from the copy quantities to the reproduction ratio of a job by pressing [%] but-
ton.
When the [25%] and [100%] buttons are pressed simultaneously, the reproduction ratio is instantly
set at 25%. When the [200%] and [100%] buttons are pressed simultaneously, the reproduction ratio
is instantly set at 200%.
3) Total counter
The total counter value is displayed by pressing the [#] button more than 2 seconds. The total 8 dig-
its can be displayed; the first 2 digits of the value are displayed at first, then the next 3 digits, and
then the last 3 digits are displayed in order.
e.g.) 12345678: 12%345%678
When the [25%] button is pressed, the digits shift to the 3 digits of next higher order. When the
[200%] button is pressed, they shift to the 3 digits of next lower order.
4) ROM version
A ROM version is displayed by pressing the [*] key, the [#] key and the [START] button simulta-
neously. The total 8 digits can be displayed; the first 2 digits of the ROM version are displayed at
first, then the next 3 digits, and then the last 3 digits are displayed in order.
e.g.) 12345678: 12%345%678
When the [25%] button is pressed, the digits shift to the 3 digits of next higher order. When the
[200%] button is pressed, they shift to the 3 digits of next lower order.
5) Error code
When a paper jam or a service call has occurred, its error code is displayed in 3 digits by pressing
the [CLEAR/STOP] button and the [8] key simultaneously.
6) Auto Power Save Mode / Auto Shut Off Mode
“ALP” (Auto Low Power) is displayed during the Auto Power Save Mode, and “SLP” (Sleep) is dis-
played during the Auto Shut Off Mode.
To Next Page
Loading...
