11
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
DRUM RELATED SECTION
11 - 9
11.7 Disassembly and Replacement
[A] Process unit
(1) Open the ADU cover and transfer unit.
(2) Open the front cover and take off the toner
cartridge.
(3) Disconnect 1 connector. Loosen 2 screws
and pull out the process unit.
Note:
When installing the process unit, make sure
that the connector (harness) is not caught
under the developer unit.
Fig. 11-6
Fig. 11-7
Process unit
for MJD
Process unit
except for MJD
07/03
To Next Page
Loading...
