Toshiba e-STUDIO 206

To Next Page

To Previous Page

DRUM RELATED SECTION

11 - 10

[B] Drum cleaner unit

(1) Take out the process unit.

" P.11-9 "[A] Process unit"

(2) Disconnect 2 connectors and remove 2

screws.

(3) Release 1 latch. Then pull out the process

unit front cover and take it off.

Note:

When installing the process unit front cover,

wire the harness correctly in order not to con-

tact the gears and harness of the process

unit front cover each other.

Fig. 11-8

Fig. 11-9

Fig. 11-10

Process unit front cover Connector

Connector

Latch

for MJD

Process unit front cover Connector

Connector

Latch

except for MJD

Process unit

front cover

Harness

07/03

Toshiba e-STUDIO 206 - Page 170