Toshiba e-STUDIO 206 - Bypass Feed Copying; Interruption Copying

e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 4
4.2.4 Bypass feed copying
1) Insert a sheet of paper into the bypass tray.
!Bypass paper sensor ON
- Bypass feed priority state
2) Press the [START] button
!LED “START” ON !OFF
!CIS LED ON
!Scan motor ON % CIS unit move forward
!Polygonal motor rotates in high speed
!Main motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
!Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
!Bypass pickup solenoid ON
- The bypass pickup roller start to rotate.
- The bypass pickup roller is lowered.
- The bypass feed roller start to rotate.
!Paper reaches the registration roller
!Aligning operation
!After a certain period of time, the bypass pickup solenoid OFF
4) Hereafter, the operation 3) through 6) of " P.4-3 "4.2.3 Drawer feed copying" is repeated.
4.2.5 Interruption copying
1) Press the [INTERRUPT] button
!LED “INTERRUPT” ON
!Copying operation in progress is temporarily stopped. CIS unit return to appropriate positions.
!Automatic density and reproduction ratio 100% are set (The set number remains the same)
2) Select the desired copy condition
3) After the interruption copying is finished:
!LED “INTERRUPT” OFF by pressing the [INTERRUPT] button
!Equipment returns to the status before the interruption
4) Press the [START] button
!The copying operation before the interruption is resumed.