9
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
DRIVE UNIT
9 - 7
[C] Main motor drive unit
(3) Remove 2 screws and take off the toner
motor.
Fig. 9-5
(1) Take off the Process unit.
" P.11-9 "[A] Process unit"
(2) Take off the toner motor with the bracket.
(3) Remove 2 screws and take off the registra-
tion roller holder.
Note:
When installing the registration roller holder,
align the arm of the registration roller clutch
with the rotation stopper of the registration
roller holder.
Fig. 9-6
(4) Remove 1 clip and take off 1 bushing.
Fig. 9-7
Tonner motor
Bracket
Registration roller holder
Rotation stopper
Clip Bushing
To Next Page
Loading...
