10
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
PAPER FEEDING SYSTEM
10 - 15
[G] Bypass sensor (S8)
(1) Remove 1 screw on the bottom of the equip-
ment.
(2) Take off the bypass sensor with the bracket.
Fig. 10-20
(3) Take off the actuator with the spring while
pushing the bracket stays wider.
Fig. 10-21
(4) Release 2 latches, take off the bypass sen-
sor, and disconnect the connector.
Fig. 10-22
Bracket
Actuator
Spring
Bracket
Bracket
Connector
Bypass sensor
To Next Page
Loading...
