e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 20
[K] Paper empty sensor (S7)
(1) Take off the drawer.
(2) Take off the damp heater unit or dummy
plate.
" P.10-19 "[J] Damp heater unit (DH3) /
Dummy plate"
(3) Disconnect 1 connector, remove 1 screw,
and take off the bracket of the paper empty
sensor.
Fig. 10-33
(4) Release 2 latches and take off the paper
empty sensor from the bracket.
Fig. 10-34
Connector
Bracket
Bracket
Paper empty sensor
To Next Page
Loading...
