2
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
OUTLINE OF THE MACHINE
2 - 21
[G] ADU cover
[H] Right front cover
(1) Open the bypass tray.
(2) Open the ADU cover.
(3) Open the transfer unit and release the ADU
stopper on the front side.
(4) Remove 1 screw and take off the ADU stop-
per on the rear side.
Note:
Be careful not to fall off the ADU cover when
the screws are removed from the ADU stop-
per.
Fig. 2-18
(5) Take off the ADU cover while sliding it toward
the right.
Fig. 2-19
(1) Take off the front cover.
" P.2-18 "[A] Front cover"
(2) Open the ADU cover.
(3) Pull out the drawer.
(4) Remove 2 screws and take off the right front
cover.
Fig. 2-20
ADU stopperADU stopper
ADU cover
Right front cover
To Next Page
Loading...
