Toshiba e-STUDIO 206 - Page 61

3
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
COPY PROCESS
3 - 7
- Magnetic roller
Magnetic brush development
The south and north poles are arranged inside the magnetic roller as shown in the right figure.
The developer material forms a brush-like fluff which contacts the photoconductive drum surface.
#
This is caused by the magnetic force lines between the south and north poles.
Fig. 3-13
N
S
S
Magnetic force
line
Magnetic roller
Photoconductive
drum