4
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
GENERAL OPERATION
4 - 7
(C) Misfeed in equipment
• Exit sensor detects jamming of the leading edge of paper.
#
Registration clutch ON
Fig. 4-1
#
Less than 1.808 sec.
Exit sensor ON
If the exit sensor is not turned ON after 1.808
sec.
#
Paper jam (E01)!% The copying operation is
stopped.
• Exit sensor detects jamming of the tailing edge of paper.
#
Registration clutch OFF
Fig. 4-2
#
Less than 1.759 sec.
Exit sensor OFF
If the exit sensor is not turned OFF after 1.759
sec.
#
Paper jam (E02)!% The copying operation is
stopped.
• Immediately after the power ON
#
Any of all sensors on paper transport path detects paper (ON)
#
Paper jam (E03)
• Front cover is opened during copying
#
Paper jam (E41)
• Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the feeding starts.
#
Paper jam (E12, E13 and E21: Error code differs depending on the paper source.) Refer to the
error code table in Service Handbook.
Registration clutch
Exit sensor
Timer
0
Paper jam (E01)
ON
ON
1.808sec.
Registration clutch
Exit sensor
Timer
0
Paper jam (E02)
ON
OFF
1.759sec.
To Next Page
Loading...
