-72-
6. Configuring at the Operator Panel
This chapter explains how to configure the equipment settings from the <SETTING> key on the
operator panel.
Changing the Equipment Settings
This section explains the basic procedure to change the equipment settings.
Reference
z For details on the menu structure of the equipment settings, refer to "Device Setting Menu" P. 74.
Memo
z An item which cannot be re-set is indicated as [---].
Admin Setup or Easy Setup
To enter the [Admin Setup] menu or the [Easy
Setup] menu, an administrator password is
necessary.
Memo
z The default password is "aaaaaa".
1 Press the <SETTING> key to open the
equipment setting menu.
2 Press the to select [Admin Setup] or
[Easy Setup] and then press .
3 Enter the administrator password.
4 Select [Enter] and then press .
5 Press the to select the setup menu on
which you want to change a setting and
then press .
6 Change the setting and then press
For [Easy Setup], repeat step 6 until the
message indicating the setting completion is
displayed.
7 For [Admin Setup], press the until
the top screen appears.
For [Easy Setup], press the to
complete the setup.
Memo
z If you want to cancel the setup of [Easy Setup], press
<RESET/LOG OUT> key.
Other Menus
1 Press the <SETTING> key to open the
equipment setting menu.
2 Press the to select the setup menu on
which you want to change a setting and
then press .
3 Change the setting and then press .
4 Press the until the top screen appears.
OK
OK
OK
OK
OK
To Next Page
Loading...
