Toshiba e-Studio 332s - Page 85

List of the Device Setting Menu Items
-85-
Configuring at the Operator Panel
6
Security
Function
ID Check Tx OFF Sets whether to use the ID check trans-
mission.
Broadcast Destination ON Sets whether to indicate the destination
number before starting broadcast trans-
mission.
Confirm Dial OFF Sets whether to reenter the destination
fax number before sending a fax.
Secure Receive Setting OFF Sets whether to use the secure receive
function.
Password (NULL) Sets password for printing received docu-
ments in memory.
Other
Settings
Redial Tries 2 times Sets the number of redial attempts.
Available range: 0 to 9 times.
Redial Interval 1 minute Sets the time between redial attempts.
Available range: 1 to 5 minutes.
Block Junk Fax Setting OFF Sets the mode of Block Junk Fax.
Registered
List
Register/Edit (No Entry) Register/Edit addresses for Block Junk Fax.
Display condition: [
Admin Setup ]>[ Other
Settings
]>[ Block Junk Fax ]>[ Setting ] is
set to [ Mode2 ].
Delete (Nothing: con-
nect Item cell
and Factory
default cell)
Delete addresses for Block Junk Fax. Dis-
play condition: [Admin Setup]>[Other
Settings]>[Block Junk Fax]>[Setting] is
set to [Mode2].
Ring Response 1 ring Sets the number of rings required before
receiving an incoming fax.
Dialing Pause Duration 2 seconds Sets the dial pause time.
Available range: 0 to 10 seconds.
Rx Reduc. Rate Auto Sets the reception reduction rate.
Reduc. Margin 24 mm or 3.9
inch
Sets the threshold level of reception
reduction.
Available range: 0 to 100 mm
(0 to 3.9 inches).
ECM Mode ON Sets whether to use the error correction
mode.
PreFix NULL Sets the dialing prefix. Maximum 40 dig-
its.
Received Time Stamp OFF Sets whether the time stamp is printed on
incoming faxes.
Print Check Message ON Sets whether the error content is reported
when a transmission error occurs.
Fax
Setting
Service Bit OFF If set OFF, some menu items are not dis-
played on the panel.
Country Code International
or U.S.A or
Australia(Sin-
gapore)
Sets the country code.
A/R Full Print ON Sets whether to print the list of the com-
munication results automatically after
every 50 communications.
Tone For Echo (For Transmission) Disable It only shows, when ServiceBit = ON.
Tone For Echo (For Reception) Disable It only shows, when ServiceBit = ON.
Item
Factory
Default
Description