Toshiba e-Studio 350 - Page 510

e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 74
[CB31] Movable tray paper-full detection error
[CB40] Rear aligning plate motor abnormality
[CB40] Front alignment motor abnormality
MJ-1101
Is there any mechanical problem when the actuator of the movable tray paper-full detection
sensor (S17) is moved?
È
ÆYES Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the movable tray
paper-full detection sensor (S17)?
l
l
È
ÆYES • Connect the connector securely.
• Reinstall the sensor correctly.
• Replace the sensor.
NO
Is the harness between the movable tray paper-full detection sensor (S17) and the finisher
control PC board (CN13) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Replace the finisher control PC board.
MJ-1023/1024
Is the rear aligning plate home position sensor (PI37) normal?
È NO Æ Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the rear aligning plate motor (M34)
correct?
È NO Æ Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
È NO Æ Fix the mechanism.
YES
1) Replace the rear aligning plate motor.
2) Replace the finisher controller PC board.
* You receive a [CB40] error when the [ED13] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the front alignment plate is moved?
È
ÆYES Fix the mechanism.
NO
Is the harness between the front alignment motor (M9) and the finisher control PC board
(CN10) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
Replace the front alignment motor (M9).
06/01