70
3.SETTING ITEMS (USER)
3
4. SETTING SCAN FUNCTIONS
You can change the initial setting (default setting) of scan job.
The [SCAN] button in the [USER] menu will be available only when the Printer Kit and Scanner Upgrade
Kit are installed, or when the Printer/Scanner Kit is installed.
1
Press the [USER FUNCTIONS] button on
the control panel to enter the User
Functions menu.
2
Press the [USER] button, and then press
the [SCAN] button on the touch panel.
- The SCAN screen is displayed.
3
In the “2-SIDE SCAN” option, press the
desired mode button.
- [SINGLE] — Press this to set single page scan as default scan
mode.
- [BOOK] — Press this to set book scan mode as default scan
mode. This enables to scan both side of originals in the same
direction.
- [TABLET] — Press this to set tablet scan mode as default scan
mode. This enables to scan front page in the general direction,
and scan back page rotated 180 degree.
4
In the “ROTATION” option, press the
desired mode button.
- [0 degree] — Press this not to rotate the scanned image as
default.
- [90 degree left] — Press this to rotate the scanned image 90
degrees on the left as default.
- [180 degree] — Press this to rotate the scanned image 180
degree as default.
- [90 degree right] — Press this to rotate the scanned image 90
degree on the right as default.
To Next Page
Loading...
